Oliver Petik

Service entrance — Meter & panel

Panel — Dead front ON

Panel — Dead front OFF

Problem area — Before

Measure and document working clearances around Murray load center per NEC requirements

Verify panel condition and compatibility of Bryant breakers in Murray panel

Identify all kitchen receptacles and verify GFCI protection status

Assess feasibility of relocating panel one stud bay including service entrance cable length, conduit runs, and structural considerations

Review YES contractor report if available onsite

Current panel location showing washer proximity

Panel interior showing Murray equipment and Bryant breakers

Kitchen receptacles identified as non-GFCI protected

Proposed panel relocation area

Service entrance configuration

Problem area — After

Work summary

Completion — Clean workspace

Document feeder wire gauge and labeling

Photograph 125A breaker nameplate and rating

Document panel nameplate showing 70A max branch

Inspect feeder connections for heat damage

Verify upstream breaker protecting these feeders

Check for signs of overheating on panel